TL;DR — the picks
- The value pick: BATLEXP G350 — from £94.90. A small vertical handheld with the Vectrex among the 39 platforms configured and verified on its replacement dArkOS firmware, running through the VecX emulator. It is the best-stocked device I sell.
- The clamshell: Anbernic RG DS — from £147.90. The biggest 4:3 screen here at 4.0 inches, with the Vectrex among its 39 configured platforms, running through the VecX emulator. One of the two devices I am actively stocking, alongside the G350 — though it is purpose-built for the Nintendo DS.
- Final-stock vertical option: Anbernic RG353V — from £169.90. A lightweight vertical body, dual-boot firmware with the Vectrex configured on it, and the same sharp 3.5″ 228 PPI 4:3 panel as the G350. Two single units remain; I am not restocking it.
Every device here is dispatched from the UK. Prices and stock are correct as at the time of writing.
The machine itself — the one with its own screen
Every other console in this series plugged into a television. The Vectrex did not need one: it drew its picture on a screen of its own — a vector display, and the only home console ever to ship with one — the image made of glowing lines rather than dots. General Consumer Electronics launched it in North America in 1982, and Milton Bradley brought it to Britain the following year. The screen showed a monochrome picture, so each cartridge shipped with a printed plastic overlay that clipped onto the display — colour, artwork and framing for the game underneath it. The console carried a game of its own inside it, no cartridge needed, and a joystick with four buttons that folded away into the body. The American video game crash ended its run by the mid-1980s, and the machine has stayed a curiosity since: a strange, beautiful corner of the era this series covers — the Atari 2600 and Atari Lynx articles sit on either side of it.
Why the chip is not the decision
The Vectrex is early-1980s hardware, and its software is a light load for anything modern. Every processor here, from the G350’s entry-level RockChip RK3326 upwards, runs these games at full speed. You cannot pay extra for a device that runs the Vectrex better, and no chip in the range breaks a sweat over it. The decision is about the screen, the shape of the device, and the controls — the same conclusion the Master System, Game Boy and Commodore 64 articles reached for their platforms.
The screen question — a tall picture, framed
The Vectrex drew its picture taller than it was wide — a portrait shape, the opposite of nearly everything else in this series. On the 4:3 panels on this page, the 640×480 screens, that picture centres as a tall column with margins either side, shown at its correct proportions rather than stretched or cropped. The margins are not wasted space on a configured device: on the G350 and the RG DS, each game loads with its own overlay configuration that recreates the original plastic overlay in the side space — the colour and artwork the machine was designed to be played with, not a plain black frame. I have not seen another seller configure these. Beyond the overlays, the vector look itself is tuned: on the G350 the picture renders with a soft phosphor-style glow, the effect that makes vector games read as glowing lines rather than thin white ones. The 3.5″ panels on the G350 and the RG353V are 228 PPI, sharp for this picture, while the RG DS gives its top screen more physical space at 4.0″ and 200 PPI.
The input question — a joystick, four buttons
The Vectrex’s controller was a self-centring analogue joystick with four action buttons — simple by any standard, and every gamepad on this page carries more inputs than a Vectrex game ever uses. The one genuine difference is the stick: the original was analogue, and the RG DS answers it directly with its left analogue stick, which I have tested working with the platform. The G350 and RG353V play these games on a directional pad, which is comfortable and precise for everything here, just a different feel from a 1982 joystick. If a specific game is the one you are buying for, contact me first and I will check it for you.
The picks in detail
The value pick — BATLEXP G350 (from £94.90, in stock)
The G350 is the cheapest device I sell, and on the Vectrex it gives up nothing to the dearer ones. Its RockChip RK3326 is the entry-level chip in the range, and on a 1982 console it is the equal of everything above it: the Vectrex is among the 39 platforms configured and verified on its replacement dArkOS firmware, every one tested and working, with the games running through the VecX emulator. The configuration goes further than the platform list: each Vectrex game loads with its own overlay configuration recreating the original plastic overlay, and the vector picture renders with a phosphor-style glow. The 3.5″ 4:3 IPS panel — 640×480, 228 PPI, the same sharp screen as the RG353V — shows the tall picture at its correct proportions, framed by the overlay artwork. It is a small vertical body that slips into a pocket, and it is the best-stocked device I sell, with 24 units across its colour and card options at the time of writing. What the lower price buys out of is everything past the 8-bit era: the RK3326 is a 2D-first chip, excellent through the Game Boy and the Mega Drive, good for the PS1, and honest about where it stops.
- 3.5″ 4:3 IPS screen, 640×480, 228 PPI — the same sharp panel as the RG353V
- RockChip RK3326 — Vectrex tested and configured among 39 platforms on dArkOS, via the VecX emulator, with per-game overlays and glow rendering
- Small vertical pocketable body
- See the BATLEXP G350
The clamshell — Anbernic RG DS (from £147.90, in stock)
The RG DS headlines 39 configured platforms with the Vectrex among them, running through the VecX emulator on its RockChip RK3568 chip. The picture sits on the biggest 4:3 screen on this page — the 4.0″ top panel, 640×480, 200 PPI — and it carries the same per-game overlay configuration as the G350, each game framed with its original colour and artwork. Its left analogue stick is the closest input match here to the Vectrex’s original joystick, tested working for the platform. The clamshell form suits a machine you will want to protect: it closes over its own screen, so it travels in a way a bare slab does not. It is one of the two devices I am actively stocking alongside the G350, with nine units across five options at the time of writing. The honest caveat is the one this series has given before: the RG DS exists for the Nintendo DS, and its second screen and touch hardware go unused by a Vectrex game. If dual-screen gaming is a draw alongside the classics, the RG DS covers both; if the Vectrex is your only priority, the same money goes further elsewhere.
- 4.0″ 4:3 IPS top screen, 640×480, 200 PPI — the biggest 4:3 screen here
- RockChip RK3568 — Vectrex among 39 configured platforms, via the VecX emulator, with per-game overlays; left analogue stick tested for the platform
- Replacement GammaOS Next firmware with Daijishou frontend; clamshell, dual-screen, touch
- See the Anbernic RG DS

The final-stock option — Anbernic RG353V (from £169.90, in stock)
The RG353V pairs the same 3.5″ 4:3 panel as the G350 — 640×480, 228 PPI — with the range’s more capable RockChip RK3566 chip and dual-boot firmware: ArkOS on Linux and GammaOS-RK3566 on Android, with the Vectrex among the platforms configured on it. It is a lightweight vertical pocket device with a multi-touch panel, and that extra headroom matters if the Vectrex is the start of a collection rather than the whole of it — the Dreamcast and PSP articles cover what the RK3566 does that the RK3326 does not. This is final stock — I am not restocking it, and two single units remain across its colour options.
- 3.5″ 4:3 IPS screen, 640×480, 228 PPI, multi-touch (the same sharp panel as the G350)
- RockChip RK3566
- Dual-boot ArkOS + GammaOS-RK3566
- See the Anbernic RG353V

How to choose
- You want Vectrex games for as little as possible: G350. Full-speed Vectrex among 39 tested and configured platforms, with per-game overlays and glow rendering, in a vertical pocketable body from £94.90 — and the best-stocked device I sell.
- You want the biggest 4:3 screen, the overlay treatment and an analogue stick: RG DS. Vectrex among 39 configured platforms on a 4.0″ top screen, per-game overlays, and the closest input match to the original joystick — in a clamshell, with the Nintendo DS as its second string.
- You want a vertical pocket device with dual-boot firmware and headroom for later consoles: RG353V. The same sharp panel as the G350 plus multi-touch and the RK3566 chip — two single units, final stock.
Why a configured handheld plays Vectrex games better than a factory one
Every device on this page runs a replacement firmware rather than the stock operating system it ships with — dArkOS on the G350, GammaOS Next on the RG DS, and dual-boot ArkOS and GammaOS-RK3566 on the RG353V. On each of them the work shows in the places a factory device gets wrong: controls mapped correctly, screens scaled properly, and platforms tested and tuned rather than left at the defaults a direct import arrives with. The Vectrex is where that tuning is easiest to see — on the G350 and the RG DS each game carries its own overlay configuration, a detail no factory setup carries and one I have not seen from any other seller. The Arcade article covers the coin-op side of the same era, and the full picture of what changes between a factory handheld and one of mine is on The K-TEC Difference. If you are weighing a pre-configured UK device against a marketplace import, I have put that comparison in one place: K-TEC compared with other suppliers.
Beyond the software, each device has had the factory SD card removed and replaced with a brand-name card from SanDisk, Samsung or Kioxia, and every card is covered by my Lifetime SD Card Guarantee — for the life of the device, if the card fails or its data corrupts, I replace the card or restore it. A failed card is the single most common way a retro handheld dies, and it takes your saves with it. I wrote about exactly why that happens, and how I remove the risk, in Why Do Retro Handheld SD Cards Keep Failing?. Every device ships from UK stock by Royal Mail Tracked 48, arriving in 2–3 working days, with UK-based support on the other end of the phone.
The short version
The Vectrex is 1982 hardware, so power is not the story — it runs at full speed on every chip in the range, with the platform tested and configured on all three devices here. Its picture is a tall one, shown at correct proportions on the 4:3 panels and framed — on the G350 and RG DS — by per-game overlays that carry the original colour and artwork. The G350 is the value pick — vertical, pocketable, from £94.90, with overlays and glow rendering, and the best-stocked device I sell. The RG DS runs the platform through the VecX emulator on the biggest 4:3 screen here, with per-game overlays and an analogue stick, inside a protective clamshell. The RG353V puts the same sharp panel in a dual-boot vertical body — final stock, two single units. If you are unsure which fits you, contact me and I will point you at the right one.

Leave a Reply